CHEMICAL INJECTOR STRAINER: ORIGINAL PVC SLOTTED FILTER FOR SH

This is an original slotted PVC filter approximately 1" x 8-12" long with a 1/4" poly hose barb. This original slotted PVC filter is suitable for use with a chemical injector on a pressure washer. This filter does not have a check valve. This filter is finely slotted but allows for tremendous flow. Beware of filters that offer a nylon screen or low grade stainless steel screen over the PVC. The nylon and SS screen will break down quickly and end up sucked into the pump.

Installed with an elbow for top draw from tank and to allow user to fit the slotted filter end into the bung opening of a 55-gallon drum or tank opening.

You can fabricate and provide a PVC sleeve to slip over hose to keep filter at bottom of tank out of 1/2" SCH 40 PVC.

Do not hard pipe plumb this filter into the tank. You must be able to remove the slotted filter to clean the debris and salts from the surfaces.

***Rex, the Pump Guru, invented this slotted filter for use with sodium hypochlorite.***

FYI:

The general rule of thumb when plumbing a pump is as follows:

We can provide this filter with two elbows for the dual port chemical injector. Both hoses should be the exact same length and diameter.

Condition: New

SKU: TF-C