S/EB4040HG-E SKID COLD 4GPM 4000PSI POWER WASHER KEY START

Pressure-Pro electric key start skid mounted cold 4 GPM 4000 PSI power washer S/EB4040HG-E.

Please order this unit by calling 727-562-5488 or 800-519-9279 M-F 8a-5p EST. We ship everywhere.

4 GPM 4000 psi Honda GX390 13 hp  V-belt on the new standard powder coated steel frame, marine battery box, 50 mesh inlet filter, commercial unloader, low oil shutdown, thermal relief valve, gun/wand assembly with quick connects, 50' high pressure grey hose with quick connects, 5 quick connect nozzles, 20% high draw chemical injector assembly with quick connects.

We highly recommend adding the best high pressure 3/8" ball valve (6292) to this order to allow you to turn off the flow of water to switch from the gun to a Whisper Wash 16" Ultra surface cleaner (6717).

The 16" Whisper Wash Ultra with the upgraded 3/8" high pressure hose is the perfect complement to this cold pressure washer.

If supplying with a garden hose from a property, use a 3/4" ID garden hose. If supplying water from a tank, use 1" non-collapsible suction hose (AGC16) with a 1" y-strainer (YS16H). We have a 4 GPM plumbing kit for pressure washers that includes everything needed to plumb this unit to a tank.

Install a high temperature Hudson float valve (Hudson-ht) using everything you need to install it with our Hudson assembly (Hudson-A). The Hudson assembly installs into the very top of the tank using a bulkhead and garden hose connection to prevent the tank from over-flowing.

This unit is available in skid or portable cart for the same cost.

Inlet line size should be adequate to avoid starving the pump.  Line size must be a minimum of one size larger than the pump inlet fitting. Avoid tees, 90-degree elbows or valves in the inlet line of the pump to reduce the risk of flow restriction and cavitation, The line must be a flexible hose, not a rigid pipe, and reinforced on suction systems to avoid collapsing, the simpler the inlet plumbing the less the potential for problems. Keep the length to a minimum, the number of elbows and joints to a minimum (Ideally no elbows) and the inlet accessories to a minimum. Use pipe sealant to assure air-tight, positive sealing pipe joints.

(http://www.catpumps.com/products/pdfs/993418b_ref_inlet%20condition%20check%20list_lor.pdf)